Selleys Malaysia
all_clear
Available Sizes
  • 270g Cartridge
  • 75g Tube
Top 5 Problems:
  1. Broken something made of plastic and don’t know what will fit it?
  2. Broken a glass vase?
  3. Mould growing on your bathroom silicone?
  4. Laminate furniture starting to peel?
  5. How to stop a door hinge from squeaking?

v_all_clear

All Clear
Is a high grade sealant that is quick and easy to apply giving a clear finish. Providing long lasting protection even on wet and oily surfaces, paintable and water resistant.

  • Glazing
  • Roofs
  • Guttering
  • Brick
  • Cement
  • Timber
  • Window Frames
  • Many Plastics
  • Sink
  • Basins

 

  • Glass like clarity - dries clear to blend with the surface.
  • Suitable for old and new surfaces as it cuts through light oil deposits for excellent adhesion and seals effectively even on weathered surfaces.
  • Suitable for damp non-porous surfaces eg metals, glass, glazed tiles.
  • Paintable with oil and water based paints.
  • Multipurpose - can be used on most building materials and won't crack or dry out.
  • Mould resistance as it contains a fungicide to protect against unsightly mould growth.
  • Good weatherability and resistance to UV light.
  • Excellent gap filling characteristics.

 

  • Ensure the surface is clean, dry and free from dust, grease, flaking/powdery paint and old or crumbling caulk. If the surface is non-porous eg glass or metal, firstly clean the surface with Mineral Turpentine and then again with Methylated Spirits.
  • For a smooth finish, smooth with a wet finger or scraper, dipped in mineral turpentine.
  • If the surface is wet, remove as much water as possible, preferably with acetone and apply as stated above. However flatten into joints immediately.
  • To clean up the excess, wipe excess away with a cloth dampened in mineral turpentine. Remove dried sealant from skin with petroleum jelly.
  • Avoid smearing on surrounding surfaces, see handy tip.
  • Sealant will skin immediately, and fully cure after several days. At this point any unwanted sealant can be removed by trimming with a sharp blade, but avoid under cutting the seal.
  • Can be painted immediately with water based paint. If the paint is oil based paints, firstly paint the surface with a water based under coat straight after ALL CLEAR has been applied.

 

  • Ensure you tape both sides of the gap before applying the product. This ensures a neat finish and makes it easier to clean up.
  • When first applying product, extrude a small amount onto a piece of scrap material to ensure a smooth continuous flow of ALL CLEAR.
  • Remove the tape before the sealant skins.
  • If the weather is cold ALL CLEAR can thicken and be harder to get out from the cartridge, so store the product in a warm spot before using it. ALL CLEAR applies best at room temperature 25ºC.  Do not heat ALL CLEAR as it contains flammable solvents.
  • For a better finish use a spatula dipped in mineral turpentine.

  • If swallowed, do NOT induce vomiting. If in eyes, flood the eyes for at least 15 minutes and seek medical advice.
  • Avoid contact with skin, if contact occurs, wipe off immediately and wash with detergent. It may irritate sensitive skin.
  • Avoid breathing in vapours. Intentional misuse or deliberately inhaling the vapours from this product can be harmful or fatal.
  • Ensure you use a well ventilated area.
  • Highly flammable. Vapours can be ignited by flames or sparks.
  • Avoid contamination of waterways. Allow waste or left over product to be completely dry out before disposing of it.
  • Keep away from children.

enquirydownload_msds