Selleys Malaysia
liquidnail_mirror
Available Sizes:
  • 75g Tube
  • 310g Cartridge
Top 5 Problems:
  1. Broken something made of plastic and don’t know what will fit it?
  2. Broken a glass vase?
  3. Mould growing on your bathroom silicone?
  4. Laminate furniture starting to peel?
  5. How to stop a door hinge from squeaking?

Liquid Nails Mirror & Aluminium
is a premium grade, high strength construction adhesive that has non-corrosive properties when being used on mirrors. Most other construction adhesives do not have this capability and will de-silver the mirror. Liquid Nail Mirror & Aluminum is heat and steam resistant which is important when fixing mirrors to walls in Bathrooms.

  • Mirror
  • Aluminium
  • Metal
  • Steel
  • Glass

 

  • Heat & steam resistant
  • High temperature & UV resistant
  • Will not discolour mirrors
  • Strong vertical hold
  • Non-corrosive
  • For interior & exterior use

 

  • Ensure the surface is sound, dry, and free from oil, grease and dust.
Application for mirrors:
  • For mirrors up to 6mm thick, apply strips of adhesive approximately 8cm apart. Do not apply adhesive within 5cm of mirror edge.
  • Immediately after applying adhesive, place mirror against wall before adhesive skins (within 5 minutes).
  • When mirror is pressed onto the wall, strips of adhesive must not spread into, or touch one another. A gap must remain between them.
  • Hold in place with temporary supports (e.g. with clips or tape) to maintain adhesive contact over the total bond area until sufficient adhesive strength has developed (normally after 72 hours).
  • Do not seal around the edges of the mirror for at least a week to allow air circulation.
  • Mirrors should not be fixed directly to unpainted timber, plaster, concrete or brick walls. These surfaces should be painted to prevent potential damage to mirror.
General Application:
  • Painted surfaces should not be flaky or peeling. Freshly painted surfaces should be allowed to dry for at least 7 days, before job is done. Test for compatibility on painted surfaces, before using.
  • Not for permanent water immersion.
  • Not for rigid bonds (eg. broken glass).
  • Adhesive requires air to cure.
  • Clean up while wet with mineral turps.

 

  • If repositioning materials, fresh adhesive must be applied to achieve bonding.
  • LIQUID NAIL MIRROR & ALUMINIUM cannot be used as a contact adhesive.
  • Working time is 10 minutes. Ensure surfaces are brought together before this time.
  • Wipe up any spills and for cleaning any material off the skin before it cures.

  • On contact, uncured sealant can irritate eyes.
  • If in eyes, flood with water for at least 15 minutes and seek medical advice.
  • Avoid contact with skin. If contact occurs, wipe off immediately and wash with detergent. May irritate sensitive skin.
  • Avoid breathing vapours.
  • Ensure use in a well ventilated area, product releases methyl ethyl ketoxime while curing.

enquirydownload_msds