Selleys Malaysia
multi_grip
Available Sizes:
  • 30ml
Top 5 Problems:
  1. Broken something made of plastic and don’t know what will fit it?
  2. Broken a glass vase?
  3. Mould growing on your bathroom silicone?
  4. Laminate furniture starting to peel?
  5. How to stop a door hinge from squeaking?

Multi Grip
A strong, clear, flexible multipurpose adhesive. Ideal for repair of household items and use for craft and hobby projects.

•    Metal (jewellery, toys etc)
•    Most plastics (toys, dolls etc)
•    Canvas (deck chairs, tents etc.)
•    Timber (models, toys, etc)
•    Fabric
•    Crockery

 

  • Dries Clear - No unsightly joints
  • Water resistant
  • Flexible - non-rigid bond allows some give in the joint
  • Fast bonding - Instant bond using contact method
  • An all-purpose glue which bonds most materials
  • Grabs in minutes - the exact 'grab time' depends on the surfaces to be joined
  • Interior and exterior use - can be used both outside and inside and stands up to wet weather conditions
  • Fast drying

 

  • Remove all dirt, dust and grease from surfaces to be joined.  Unscrew cap and carefully pierce diaphragm in tube with a nail or paperclip. Replace nozzle part of cap
  • Squeeze gently, apply an even coating of Multi Grip to both surfaces to be joined. Press surfaces together and clamp or hold firmly for approximately 1-2 minutes or until adhesive grabs. (Instant bonds can be achieved with the contact method by coating both surfaces and wait approximately 1 minute before pressing parts together firmly.)
  • Leave assembly undisturbed until adhesive fully dries. Approximately 10-12 hours is needed to achieve strength for normal use. Maximum bond strength is achieved after 24 hours or longer if large areas or non-porous materials are being bonded.
  • Replace cap firmly on tube for storage. Ensure no residue remains on thread of tube before replacing cap.
  • Clean up spills with acetone or nail polish remover.  (Note: these are aggressive solvents and can damage some surfaces of many materials. Its effect on the material should be trialed on an inconspicuous area first.)

 

  • For very porous surfaces - apply a thin coating of adhesive to both surfaces and allow to dry (approximately 5 minutes). Apply Multi Grip again and follow how to use guide.
  • To extend life of product always apply the cap when not in use.
  • For excess adhesive on hands, apply a solvent such as acetone (most nail polish removers) then wash off with soapy water followed by sorbolene cream or vegetable oil.

  • Handle with care, highly flammable.
  • Intentional misuse by deliberately inhaling the vapours from this product can be harmful or fatal.
  • If in eyes, hold eye open, flush with water for at least 15 minutes and obtain medical attention.
  • If skin contact occurs, remove contaminated clothing and wash before re-use. Scrape off skin while wet. Wash with plenty of soap and water.

enquirydownload_msds