Selleys Malaysia
liquid_nail
Available Sizes:
  • 3ml
Top 5 Problems:
  1. Broken something made of plastic and don’t know what will fit it?
  2. Broken a glass vase?
  3. Mould growing on your bathroom silicone?
  4. Laminate furniture starting to peel?
  5. How to stop a door hinge from squeaking?

Plastics Glue
A specially formulated adhesive and primer combination now allowing you to repair all plastic items, even those previously impossible items made from Polyethylene or Polypropylene.


  • Toys & Games
  • Car accessories
  • Kitchen plastics
  • Office items
  • Also bonds plastic to Metal, Timber, Rubber & Leather

 

  • Bonds ALL Plastics, including Polyethylene (PE) and Polypropylene (PP)
  • Easy to Apply
  • Dries clear for clean, neat results
  • Fast Bond: 2-30 seconds
  • No clamping necessary
  • No mixing required
  • Self piercing, clog free cap on adhesive

 

  • Ensure the surfaces to be joined are close fitting, clean, dry and free of dust.
  • Using the primer pen, liberally coat plastic surface/s that are to be bonded.
  • Pierce seal at end of adhesive tube by attaching nozzle and cap and turning clockwise.
  • Remove cap and apply a very small amount of glue to one surface only. Bring surfaces together and apply slight pressure.
  • The adhesive will grab within 2-30 seconds, depending on environmental conditions and materials being bonded.
  • Allow at least 30 minutes for sufficient bond strength for practical use.
  • Wipe tip of tube, replace cap and store upright in a dry cool place.

 

  • If using on leather test on an inconspicuous area first as adhesive may cause leather to discolour or harden.
  • Not suitable to repair items that will contain hot liquids.
  • Best results for nylon items are achieved without Initial priming (e.g car parts). Contact Selleys Consumer Advice if unsure of plastic type.
  • Will also bond plastic to non-plastic surfaces (Metals, Timber, China, Rubber, Leather). Do not use primer on non-plastic surfaces.
  • After use, wipe excess product from the adhesive nozzle with a tissue dipped in nail polish remover.
  • For best performance from this product after opening, store in the refrigerator or in a cool, dry place away from direct sunlight.
  • In the event that fingers get stuck together - don't panic! Slowly twist fingers in opposite direction in hot soapy water.
  • Do not squeeze tube before removing cap. Handle tube by plastic nozzle neck when opening and closing cap. This prevents pressurizing tube which may force material into cap, preventing a tight seal after use.

  • Keep Out of reach of Children
  • Avoid contact with skin and eyes and avoid breathing in vapour.
  • Bonds on contact. Should fingers stick together apply a solvent such as acetone (nail polish remover) to contact areas then wash with water.
  • Do not use solvents near eyes or open wounds.
  • Highly Flammable, keep away from sources of ignition.
  • Contents of pen may cause lung damage if swallowed.
  • This product is hazardous according to the criteria of NOHSC and HSNO. For frequent hobby or occupational use, please refer to the Material Safety Data Sheet.
  • In case of eye contact immediately flush with water for at least 15 minutes and seek medical attention.

enquirydownload_msds