Selleys Malaysia
Available Sizes:
  • 5ml
Top 5 Problems:
  1. Broken something made of plastic and don’t know what will fit it?
  2. Broken a glass vase?
  3. Mould growing on your bathroom silicone?
  4. Laminate furniture starting to peel?
  5. How to stop a door hinge from squeaking?

Supa Glue Brush On
Fast setting liquid supa glue in a self standing bottle with brush applicator. Dries clear.

  • Bonds a variety of porous and non-porous surfaces
  • Metals
  • China
  • Rubber
  • Leather
  • Some plastics


  • Bonds a variety of surfaces
  • Extremely fast setting
  • Dries Clear for clean, neat results
  • Water resistant
  • No clamping necessary
  • No mixing required
  • Maximum strength achieved in 12 hours
  • Only takes 45 seconds to achieve initial bond
  • Ideal for craft and collage applications
  • Forms a rigid bond
  • Easy to spread over wider areas from a stable self-standing bottle


  • Supa Glue works best when the surfaces to be bonded are close fitting.
  • Surfaces to be bonded should be clean, dry and free of dust.
  • Remove cap and apply a small amount of glue to one surface.  Bring surfaces together and apply slight pressure.
  • The product grabs within 10-60 seconds, depending on environmental conditions and substrates to be bonded.
  • Allow 30 minutes for sufficient bond strength for practical use.
  • Ensure cap is replaced immediately after applying adhesive, as this prolongs life of brush applicator.


  • Cyanoacrylate adhesives can create a white residue on the surface of a substrate if the area is not well ventilated.  Clean the affected area with acetone to remove residue.
  • For best performance from this product after opening, store in the refrigerator or in a cool, dry place away from direct sunlight.
  • Excellent when used with other adhesives, as the temporary tack
  • For best results, ensure surfaces to be bonded are clean, free of dust, dry and close fitting
  • In the event that fingers get stuck together - don't panic! Slowly twist fingers in opposite direction in hot soapy water.
  • Acetone (nail polish remover) or Olive oil can also be used to remove Supa Glue from skin.
  • While superglue is not recommended for use on some plastics, if your kids have broken their favourite toy, try this method:  Line up the two pieces, glue it, leave it for 24hours to dry, then drop more glue on the break area like a 'collar'/protective layer.
  • Since Supa Glue cures with moisture set times may be extended on very dry surfaces or under dry conditions.
  • Super glues cure more slowly when large amounts are used.  For faster cure use sparingly.
  • To remove excess from substrates, it is recommended that the material be soaked in a solution of acetone and water (i.e. 3 parts acetone to 1 part water). Where soaking is not possible, try placing a piece of absorbent material (eg cotton wool) soaked in acetone on the excess for 5 to 10 minutes, topping up the acetone if it evaporates.  Gently rub the surface with the material to remove the residues.  TEST THE SURFACE IN AN INCONSPICUOUS SPOT to ensure it is unaffected by acetone before attempting removal using this method.

  • Avoid contact with the skin and eyes.
  • Avoid breathing vapour.
  • Supa glue bonds on contact, if fingers should stick together, apply a solvent such as acetone to affected areas and wash off with water.
  • If no solvent is available wash area with warm soapy water and work fingers apart.
  • Do not use solvents near eyes or open wounds.
  • In case of contact with eyes, flush with water for at least 15 minutes and seek medical attention.
  • Non toxic when set
  • Quick Fix is non-hazardous once cured.  Where Supa Glue residues are on the skin, it is recommended that the skin be soaked in warm to hot water to allow easy removal. It is not advisable to try to remove the cured adhesive by pulling and scraping the skin as this will only serve to damage the skin. Alternatively rub in hand cream or vegetable oil to accelerate the natural process of the skin sloughing off to remove the residue.  Where immediate adhesive removal is considered necessary apply a solvent such as acetone (nail polish remover) then wash off with soapy water.  Apply hand cream to replace naturals oils in skin.